Four Plug Linear Actuator Motor Cable with 7 Pin Remote Controller Plug

This linear actuator cable has 4 splitters and plugs, and the remote controller/switch plug is a 7-pin female plug, it measures approximately 50cm in length. 

This cable is compatible with HHC, LMD, and FBS linear actuators that utilize a 4-plug wire harness, and the remote controller or switch plug is seven pin female.

Designed to replace a damaged linear actuator cable with the same configuration as below: 

• This replacement linear actuator cable has two bare wires on one side. One of the bare wires with terminal pin, the other one doesn't.
  
• At the other end of the cable is four splitters/plugs:
  • A round 7-pin female plug connects to your remote controller or switch.
    
  • A round 2-pin male plug connects to the power supply.
    
  • A 2-pin female plug connects to deputy motor. 
    
  • A 2-pin male plug connects to deputy motor.
    

Important Notes:

• Compatibility: This cable is not a universal fit. Please only order it if your original linear actuator cable has the same configuration.
  
• Installation: Installing this cable requires dismounting the linear actuator motor. Please ensure you have the necessary knowledge or assistance before placing your order.
  
• Strain Relief: The replacement cable's strain relief might differ from the original, resulting in a slightly looser fit. To ensure a secure connection and prevent cable damage, we recommend using a zip tie to reinforce the strain relief.