eMoMo NHX034KA8HL 10-Button Remote Controller for Recliner Lift Chair with 8-Pin Right-Angle Male Plug and LCD Screen

• This is the genuine eMoMo NHX034KA8HL remote controller, featuring ten buttons and an 8-pin male plug. 
  
• It is designed for power recliners and lift chairs with one motor.
  
• This remote controller operates the chair open/close and controls its heat and vibration functions.
  

Compatibility

• This remote controller is not cross-compatible with other eMoMo NHX03 models. The NHX03 family includes many sub-models that are not interchangeable even if they look identical, and the label may only read "Model: NHX03". 
  
• To confirm this remote controller will replace yours, please carefully check the Serial Number (SN) on the barcode sticker. The SN must meet all three requirements below:
  
  • Prefix: The SN usually starts with SN:E, SN:ZWT, or SN:ZE.
    
  • Sub-Model: The characters immediately after the prefix must be exactly NHX034KA8HL or 034KA8HL.
    
  • Suffix: The character immediately after NHX034KA8HL (034KA8HL) must be a digit (0–9) or the letter V.
    
• The serial number can be found on the remote controller and the junction box. If the serial number on your remote controller is no longer readable, you can tip the chair over to check the serial number on the junction box from the downside of the chair.
  
• If yours does not match these requirements, send a photo of the barcode label to our customer support by email or through the form below, and we will help you find the correct replacement model.
  

Specifications

• Model Number: NHX034KA8HL
  
• Button Count: 10
  
• Plug Count & Configuration: 1 × 8-pin male plug 
  
• Rated Voltage: 29V DC, 2A
  
• Power: 59W max
  
• Cable Length: 1.45m/4.76ft
  

Key Features

• 10-Button Control: 
  
  • Operates the chair Open/Close
    
  • Turns heat ON/OFF 
    
  • Turns vibration ON/OFF 
    
  • Operates the vibration intensity, vibration area, vibration modes. 
    
  • Sets the time duration. 
    
• 8-Pin Right-Angle Male Plug: Features an 8-pin right-angle male plug to connect to the control box. 
  
• LCD Screen: Shows time, zones, intensity level, current mode, and other status readings. 
  

Troubleshooting

• A common issue with this remote controller is a short circuit in the vibration motor or heating plate. Any of these can prevent the remote controller from functioning properly. Follow the steps below to find out which component is at fault.
  
• Disconnect All Connections:
  
  • Turn the chair upside down.
    
  • Locate the junction box.
    
  • Unplug every cable from the junction box.
    
• Test the Remote Controller:
  
  • Reconnect only the remote controller, lifting motor, and power adapter.
    
  • Try using the remote controller.
    
    • If it works: the fault is in one of the components you unplugged. Reconnect them one at a time; the one that makes the remote stop working is the faulty part. Leave it unplugged.
      
    • If it still doesn't work: the fault is in the remote itself or the control box.
      

Package Includes

• 1 × eMoMo NHX034KA8HL Remote Controller